Vehicle will not start @ all..!!

What about the IAC, was it cleaned?
Did you check for trouble codes?

Is the IAC located on the throttle body as well?? Im not sure where it's located.. I'm new to trying to figure out about the vehicle b/c it so electronic& I'm just trying to learn my vehicle..& I appreciate all the help y'all are giving! I can't check for trouble codes b/c I can't get it started to get to auto zone or any where..

Yes, it is at the throttle body.

I did take that off& clean inside of there as well..still nothing..

Did you use carb cleaner to clean?

I bought throttle body cleaner to clean it..

Try this to see if it helps. Repeat if necessary.

Idle Air Volume Learning Procedure

1. Turn ignition switch on. Wait at least one second. Turn ignition switch off. Wait at least ten seconds.

2. Start engine. Warm up to normal operating temperature. Turn ignition switch off. Wait at least ten seconds.

3. Start engine and let idle for at least thirty seconds.

4. Disconnect Throttle Position (TP) sensor harness connector (Brown), then reconnect it within five seconds. Wait twenty seconds.

5. Ensure idle speed is within specifications. If idle is not as specified, result will be incomplete.

6. Rev engine two or three times. Ensure idle speed and ignition timing are within specification.

I followed your exact directions..the only difference is I had o keep my foot on the as pedal to keep it idled each time..same results..it just gave out on me

Have rechecked the air hose between MAF and throttle body for vacuum leakages? Try cleaning the MAF as well.