ABS lite on,will not shift out of first,code tester w/n test

1998 CHEVROLET S-10
145,000 MILES
Advertisement
Avatar
KEBBLER69
  • MEMBER
  • 27 POSTS
is your answer the same as OCT 30?
Nov 2, 2011 at 9:46 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Who told you it could be the body control module?The body control module controls body functions like door locks keyless entry security lighting etc.Again to test it there really isnt a bench test you would have to make sure the wires were good terminal tightness power and ground to the body control module.
Nov 2, 2011 at 10:23 PM
Advertisement
Avatar
KEBBLER69
  • MEMBER
  • 27 POSTS
i saw a wiring dirgram and the vss and abs goes or comes thur it
Nov 2, 2011 at 10:49 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Yes it would because the body control module runs the cluster so the vss would have a input for the speedometer.Also you have a abs light on the dash that turns on so that would be the abs input.
Nov 2, 2011 at 10:54 PM
Avatar
KEBBLER69
  • MEMBER
  • 27 POSTS
could this cause my problem ? and also would a ECP solenoid on the trany cause it also?????????????
Nov 3, 2011 at 12:38 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Heres the problem you had a lot of codes from all different circuits so to say the ecp solenoid caused all these codes on these many different circuits would be impossible.Have you had any problems starter the car like the starter turning the engine over?Have you made sure the battery cables are clean and tight?Also have you had the alternator and battery tested?
Nov 3, 2011 at 1:02 AM
Avatar
KEBBLER69
  • MEMBER
  • 27 POSTS
no working ok,all tested good this summer,my trany was leaking at the ecp soenoid and trany guy changed it and the harness and was useing my 4 week and half before this started?????????
Nov 3, 2011 at 1:19 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
If that harness connects all the other shift solenoids to it then that could be possible to set all the shift solenoid codes.
Nov 3, 2011 at 1:38 AM
Avatar
KEBBLER69
  • MEMBER
  • 27 POSTS
I have no clue what it ties in with,I just know it was changed?????
Nov 3, 2011 at 1:55 AM
Avatar
RIVERMIKERAT
  • CERTIFIED EXPERT
  • 6,110 POSTS
kebbler, did you find out what the harness in question connects to so we can finish helping you figure this problem out?
Jan 27, 2012 at 6:37 AM