VIN mismatch

Good afternoon,

The VIN has to be changed as well as the mileage from the old cluster.

Do you have access to Tech Authority for Chrysler to program the module? I do not see that option on your scan tool.

Roy

hi,

I don't have access to tech Authority for Chrysler. how can I get this?

You get a daily pass or weekly pass. Then you need to be sure your scan tool can program the ECM correctly.

The ideal scan tool is the DRB 2.

Roy

Maxi AP 200 have the option to replace PCM and write VIN on the PCM. I have seen videos and try it but i didn't have pin code for car. how can i get pin code by VIN?

You can get that from the dealer. They will have access to that information.

Roy

is there any way to extract pin code from immo or software calculate pin from VIN?

No, there is not. You need to get the information from the dealer service. They can look it up for you and get you the correct one.

The one you have may have been updated and you want the most current version for the ECM.

Roy

where is ABS cap it mention in photos you are sent?

You mean the ABS cab or control unit. Like it says, some of the models built put it in the way and it must be removed to access the ECM.

https://www.2carpros.com/articles/how-to-replace-a-abs-controller

I attached the procedure below for you.

Roy

thank you for the valuable information. if i want to install a push-button start for the car.
Acc in switch it takes ground (-) but push-button device it give (+) so i try to use resistant and relay is that right way and how i should connect resistant and relay?
and lock and unlock wire for device give (-) how also connect device wire.

You mean trying to start it without programming the ECM? If you do, no, it will not work. The ECM will not allow spark and fuel until the ECM is on board with the rest of the modules.

Roy