1999 Nissan Quest camshaft sensor position a bank one

the camshaft sensor is actually built into the distributor itself..

[quote:fe2840dda1="bluelightnin6"]the camshaft sensor is actually built into the distributor itself..[/quote:fe2840dda1]


i would also like to know why theres no current going into the sparks, the car wont start up

could be due to faulty distributor, is dist. getting power?

[quote:92c13b2318="bluelightnin6"]could be due to faulty distributor, is dist. getting power?[/quote:92c13b2318]


how do i check if the distributor is getting power?

Did you check to see if you have spark at the end of the coil wire that plugs into the distributor? You'll need to go back to basic's. Check coil wire for spark. If yes, Are your plug wires installled in the right firing order? Is your distributor reinstalled at No. 1 at TDC and your rotor is sitting on No.1 firing order. Check to insure that your distributor wire harness is pluged in and making good contact. Post back your findings.

[quote:3576513c0f="bluelightnin6"]Did you check to see if you have spark at the end of the coil wire that plugs into the distributor? You'll need to go back to basic's. Check coil wire for spark. If yes, Are your plug wires installled in the right firing order? Is your distributor reinstalled at No. 1 at TDC and your rotor is sitting on No.1 firing order. Check to insure that your distributor wire harness is pluged in and making good contact. Post back your findings.[/quote:3576513c0f]

yes i check all of these already and still doesnt work, i took the cap off the distributor and theres seems to be no power

if fuses and wiring good then dist. is most likely at fault

[quote:ed4f1df2aa="bluelightnin6"]if fuses and wiring good then dist. is most likely at fault[/quote:ed4f1df2aa]

where are the fuses located for the distributor ?

i can't seem to locate a fuse diagram for the vehicle so i'm not sure

[quote:d226bc7da2="bluelightnin6"]i can't seem to locate a fuse diagram for the vehicle so i'm not sure[/quote:d226bc7da2]

oh ok, well i replaced the distributor with another one i still keep getting the same code as the first and engine wont start