I need instructions on how to remove the bumper, replace the lens, and replace the bumper

2000 HONDA ACCORD

61,500 MILES • 4 CYL • FWD • AUTOMATIC

JIMHAYN

MEMBER
1 POST
FOLLOW

I have a broken lens on the right (passenger) brake light. In order to get to it I need to remove and replace the rear bumper. I need instructions on how to remove the bumper, replace the lens, and replace the bumper

Sep 8, 2008 at 1:25 PM

KHLOW2008

CERTIFIED EXPERT
41,814 POSTS

Hi jimhayn, TAILLIGHT REPLACEMENT - SEDAN TAILLIGHTS 1. Open the trunk lid and pull back the trunk side trim 2. Disconnect the connectors from the taillight. 3. Remove the three mounting nuts, then pull out the taillight. 4. Install the taillight, and note these items: ï¬ Inspect the gasket; replace it if it is distorted or stays compressed. ï¬ After installing the taillights, run water over them to make sure they do not leak. BRAKE/TAILLIGHT BULB: 21/5 W TURN SIGNAL LIGHT BULB: 21 W Page 1 of 1 EXTERIOR LIGHTS -2000 Honda Accord SE 9/9/2008

May 17, 2021 at 12:14 PM