Front end noise

2006 HONDA CIVIC
135,762 MILES • 0.5L • 4 CYL • FWD • AUTOMATIC
Avatar
MICHAEL WALKER2
  • MEMBER
  • 2 POSTS
I have had inner and outer tie rods replaced on both sides. New struts, new passenger ball joint. New lower control arms and bearings on both sides replaced. But I still get this pop noise when I rotate the wheel. A clunk noise when I apply brakes and then again when I apply gas. And then it squeaks now as I drive at times. It shudders at low speeds. What is wrong with my car?
Aug 13, 2017 at 1:30 AM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
it sounds as if the mechanic that did the work may have left something loose. i would get the car back there and get them to road test and recheck all their work, start here.
Aug 14, 2017 at 4:38 AM
Avatar
MICHAEL WALKER2
  • MEMBER
  • 2 POSTS
I was reading about lower ball joints. Do you have to have the car sitting on all four wheels before tightening the bolt? I think he had it still jacked up when he replaced the ball joint.
Aug 14, 2017 at 9:30 AM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
No the weight should be off the ball joint when tightening.
As you can see by the diagram below you have replaced pretty much everything. As odd as it sounds, have them check your motor mounts as well... if the engine moves around when you are off and on the gas it changes the cv joint geometry and will cause vibrations and shuddering as well as the engine making noise as it moves forward and back

Check out the guide below, it will help you figure this out

https://www.2carpros.com/articles/popping-noise

Suspension diagram attached below
Aug 14, 2017 at 2:05 PM
Avatar
ROBERT BARKER
  • MEMBER
  • 1 POST
2008 honda civic during turning it has a noise i took the wheel off and when you turn the wheel you can feel the spring making a noise like the mcpherson is dry any thing i can do to quiet it down?
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
probably a dry/bad strut bearing. you can dissemble using proper tools(spring compressor) and replace lubricate.
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
HONDA5757
  • MEMBER
  • 3 POSTS
my car makes a squeak in the front when i drive over bumps. also when i turn right and left. is it the rack and pinion or is it the suspension
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
Hi there,'

This will normally be a suspension noise, possibly dry strut seals or a dry or worn lower arm bush, you should be able to pick this up by bouncing the corners one at a time and listening and feeling for the vibration associated with this noise.

Mark (mhpautos)
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
HONDA5757
  • MEMBER
  • 3 POSTS
i have tried bouncing the front end both sides and it does not make any squeaks, can i rule out the suspension?
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
I would be thinking that it is suspension related, but not hearing it its a bit hard to tell, if its only while you are driving and turning it may be the top bearing plates on the struts, i do think that you should have some one listen to this as a mechanic should be able to pin point the noise, don't agree to any work with out telling me what they recommend first, and try and get 2 or 3 opinions, just to see if they all tally.

mark (mhpautos)
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
HONDA5757
  • MEMBER
  • 3 POSTS
i took my car into the dealership, turns out there are two recalls; one is for the auto tension pivot bolt,for the drive belt,in which, the wheels can potentially fall off and the other is for the o-ring on the speed sensor.hopefully, this solves the popping noise when i make turns.
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
DAVIDBHOME
  • MEMBER
  • 1 POST
The right side tire or front end of my car vibrates when I apply my brakes, especially when braking at high speeds. Is this a front end alignment problem, a brake problem, or a tire issue? I only notice this problem when applying the brakes. And it is very pronounced on the right side of the car.
Jan 17, 2019 at 6:53 PM (Merged)
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
have all of that checked by a pro on that side it can be any of what you mentioned.
Jan 17, 2019 at 6:53 PM (Merged)