1994 Ford Crown Victoria ERG 332 code

That code is a problem with the DPFE/PFE sensor. Did you replace this sensor

Yes i did replace the DPFE/PFE sensor Mitchel ! says there is an egrt sensor on it but Ford dealership says not. the last resort I was thinking was a partial plug in Intake .
An=y Ideas will be greatly appreciated

If you manually apply the EGR does the engine stumble real hard if not completely die? If not then it has a partially plugged passage

Manualy applying egr drops Idle But doesnot make car stumble or die. with Egr removed enrine will still run with only a slight vacuum on manifold port

Then you will need to clean out the passages.

And the only way to do this properly is to pull the Intake?

Depends on where the EGR valve mounts. Some of them you can remove the throttle bore and upper intake piece and clean out, some require further disassembly

[quote:9f06a3c3b8="2CarPro Jack"]Depends on where the EGR valve mounts. Some of them you can remove the throttle bore and upper intake piece and clean out, some require further disassembly[/quote:9f06a3c3b8]


That took care of the proble it was full of carbon

Glad to hear it