1990 Ford Bronco rear wheel bearings

Hi ,this is not that hard ,but a lot of work. first jack rear of truck up and put on jackstands.
2- remove rear wheels
3-put a pan under the rear differencial, oil will come out.
4-you will see a cover on the back of the rear end 8 or ten 13 mm bolts remove these bolts.
5-the cover will prob be stuck on pry off ,carefully so you don,t bend cover.
6- now you should have oil running out into the pan let it drain.
7-inside the differencial you will see a 5/8 steel pin spin the gear until you see a 8 mm bolt going through this pin.
8 remove this 8mm bolt pin will fall out
9-now go to the side that has the bad bearing push in on axle you will hear a c lock fall into the pan.
10-now pull axle shaft out .
11 the bearing will have to be pressed off this axle and pressed back on.

hope this helps if you have more questions write back...billymac