Does my vehicle have to be reprogrammed if I replace the accelerator position sensor?

2005 TOYOTA CAMRY
333,000 MILES • 2.2L • 4 CYL • 2WD • AUTOMATIC
Avatar
UHSNOEBIRD
  • MEMBER
  • 342 POSTS
Having a problem with the gas pedal, it doesn't want to give the motor gas when I press just a little bit on the pedal until I give it more pressure and then the car will go. Can these sensors be cleaned, and will I need to get my car reprogrammed after installing a gas pedal position switch?
Nov 2, 2021 at 6:04 AM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
Hello again,

The sensors cannot be cleaned at all. They cannot be reused either.

They do not need to be programmed either. They are plug-and-play replacements.

https://www.2carpros.com/articles/engine-hesitates

https://www.2carpros.com/articles/engine-has-low-power-output

https://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator

Verify your fuel pump is working correctly.

Also, do a compression test to be sure the timing is correct.

https://www.2carpros.com/articles/how-to-test-engine-compression

Roy

Image (Click to enlarge)
Attached Media
Nov 2, 2021 at 6:34 AM