firing order

1999 DODGE CARAVAN
147,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
CLESSARY
  • MEMBER
  • 1 POST
My van does not have any fire going to the ignition coil and it hesitated as it was out of fuel before it shut off now it won't start at all. We have checked all the fuses and we have checked the spark plug to check to see if it was firing and used a test light on the plug wire for power that unplugs from the coil. We replaced the coil now I need the firing order.
Nov 15, 2008 at 7:45 PM
Advertisement
Avatar
JNOVACK
  • CERTIFIED EXPERT
  • 723 POSTS
the coil pack gets its signal from the power control module (pcm) that gets its signal from the camshaft position sensor and the crankshaft position sensor I would look into checking those sensors if not replace them and if you still don't have spark then you should be able to remove a cover on top of engine were the camshafts are located turn engine over and see if the cams are moving if they are then the pcm needs to be tested. Here is the firing order below. Check out the diagrams (Below). Please let us know what happens.
Nov 15, 2008 at 8:26 PM
Avatar
0HEATHER757
  • MEMBER
  • 1 POST
i have a 1998 dodge caravan. i recently unplugged all the sparks plugs from the distributer cap. I need to know the firing sequence. If you would please assist me in this matter I would greatly appreciate it. Thankyou
Apr 26, 2020 at 12:48 PM (Merged)
Advertisement
Avatar
BMRFIXIT
  • CERTIFIED EXPERT
  • 19,053 POSTS
3.0 engine


https://www.2carpros.com/forum/automotive_pictures/99387_Graphic1_430.jpg

Apr 26, 2020 at 12:48 PM (Merged)
Avatar
BIGMACK532007
  • MEMBER
  • 1 POST
My van come up with a code for misfire at #4 cylinder. I just replaced the spark plugs about 1000 miles ago. Could it be a bad plug or probaly the wires? Which hole is the #4 cylinder?

Thanks,
MIke
Apr 26, 2020 at 12:49 PM (Merged)
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
Hi there, see pic for firing order 3 litre engine.


https://www.2carpros.com/forum/automotive_pictures/61395_Graphic_153.jpg

mark (mhpautos)
Apr 26, 2020 at 12:49 PM (Merged)
Avatar
AJROSE90
  • MEMBER
  • 1 POST
What is the engine firing order for a 1996 v6 dodge caravan?
Apr 26, 2020 at 12:49 PM (Merged)
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
Hello,

Here is the engine firing order in the image below just click to enlarge it.

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

Cheers
Apr 26, 2020 at 12:49 PM (Merged)
Avatar
RANDY MORTON
  • MEMBER
  • 1 POST
I would like to know the spark plug firing order for this topic?
Apr 26, 2020 at 12:49 PM (Merged)
Avatar
LOSONE
  • CERTIFIED EXPERT
  • 1,616 POSTS
Here is the engine spark plug firing order. 1 2 3 4 5 6 Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

Cheers
Apr 26, 2020 at 12:49 PM (Merged)
Avatar
U0444875
  • MEMBER
  • 2 POSTS
1989 Dodge Caravan

I took off the spark plug wires and numbered them and when I put them back on the car will not start. Can you please give me the proper configuration. Thanks.
Apr 26, 2020 at 12:50 PM (Merged)
Avatar
RASMATAZ
  • CERTIFIED EXPERT
  • 75,992 POSTS
What liter engine? Maybe we can help you out.
Apr 26, 2020 at 12:50 PM (Merged)
Avatar
U0444875
  • MEMBER
  • 2 POSTS
The engine is a 3 liter V6. We just need a diagram of the spark plug wires. Also the fan belt is torn to shreds. I found a piece of it in the grill, and the fan is not turning. Would that cause the car not to start and is it hard to put on and what tools would you need.

Thanks so much for your help.

Michelle Williams
Apr 26, 2020 at 12:50 PM (Merged)
Avatar
EMAILBOX1
  • MEMBER
  • 1 POST
#5 fuel injector is stopped up how do i fix it. Do you have a firing order diagram for 3.3 v6 dodge caravan.
Jun 19, 2020 at 1:09 PM (Merged)
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
The Injector can be bench tested and cleaned or it can be done on car as well, it car is hooked up to a special fuel system cleaner, if done off car all injectors should be cleaned and flow tested. you can also replace it if you wish, see pic for firing order.

mark (mhpautos)
Jun 19, 2020 at 1:09 PM (Merged)