Crankshaft position sensor?

2004 CHEVROLET SILVERADO
350,000 MILES • 4.3L • V6 • 4WD • AUTOMATIC
Avatar
MOONPIEI812
  • MEMBER
  • 1 POST
Crank no start after fixing wiring plug to sensor in the timing cover front and bottom of engine. What fuses, relays Should I be looking for and do i have to get the new sensor relearned?
Apr 8, 2024 at 4:14 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
Hi,

The crankshaft position sensor is controlled and powered via the powertrain control module. The PCM supplies the 12-volt, low reference, and signal circuit to the CKP sensor. So, there isn't a specific relay or fuse I can point you to.

As far as the relearn, there is a variation relearn, but that won't prevent it from starting.

Do you have spark at the plugs? If you have a live data scan tool, is there an RPM signal when cranking the engine?

I attached a pic below of the connector. I highlighted the power supply connector pin. With the key on, is there power present at that pin?

Let me know.

Joe

See pic below.
Image (Click to enlarge)
Attached Media
Apr 8, 2024 at 7:40 PM