IAT sensor

its in the air inlet duct , two wire connector , i would not do this though , all you bought was a 20 cent resistor to trick the computer into thinking its getting colder air than it is,

[quote:b9f658a158="CHEVYII"]its in the air inlet duct , two wire connector , i would not do this though , all you bought was a 20 cent resistor to trick the computer into thinking its getting colder air than it is,[/quote:b9f658a158]


I was looking into this idea. You told this person not to use the mod chip. Why not???

without getting into the logistics all it does is waste fuel , its crap , you would do better if you pulled the airbox out and cut the hole in the front bigger , it works better than any so called called air intake or mod chip because it actually pulls colder air , the cold air intakes for the engines suck hot air from the engine not from outside , ive proven it and i also have a throttle body mod i do which helps a bunch and you actually gain fuel mileage and hp and costs nothing to do , i should finish the tutorial i started for these two mods and sell those , at least you wouldnt get ripped off
i have done probably close to a hundred 4.3 engines and veryone leaving smoking the tires when they wouldnt do it when they came in

either way good luck

jim

I have a 2008 silverado with the 4.8L and just purchased a resistor for more power. I read you did not recomend doing this and was wondering if you have any other modifications for my vehicle?