UGHH PLEEEASE HELP :( !

CHEVROLET CAMARO
Avatar
MONIKAMCKAY
  • MEMBER
  • 3 POSTS
Hi my name is Monika, i have a Chevy Camaro 98 155,000 miles 3.8 Litre, I was just wondering if anyone could Pleaaase help me locate the Crank and Map sensors so i can replace them in detail ? and if its not too much i was thinking of putting power windows on this summer seing how its all manual so i was wondering if someone can tell me if that would wreck the car and what the right way to do it would be, i bought the Mitchelle repair book so if that helps maybe you can point out where on the book that would show me how .

Thank you SO Much :) !
Feb 28, 2007 at 1:25 AM
Advertisement
Avatar
SERVICE WRITER
  • CERTIFIED EXPERT
  • 9,123 POSTS
Look in the engine performance section, ignition system. I don't have the book but logically that is where I would expect it to be.


https://www.2carpros.com/forum/automotive_pictures/30961_camcam_1.jpg

The right front wheel has to come off and the harmonic balancer as well to access the cranshaft position sensor. You'll need a puller for that.
Feb 28, 2007 at 4:10 AM
Avatar
MONIKAMCKAY
  • MEMBER
  • 3 POSTS
Hi Thank you So much for your Help I really Appreciate it :D! could you tell me where the map Sensor is please ? :oops:
Feb 28, 2007 at 2:40 PM
Advertisement
Avatar
SERVICE WRITER
  • CERTIFIED EXPERT
  • 9,123 POSTS
right rear of the intake manifold, above the valve cover.


https://www.2carpros.com/forum/automotive_pictures/30961_winkbaby_3.jpg

Feb 28, 2007 at 6:42 PM
Avatar
MONIKAMCKAY
  • MEMBER
  • 3 POSTS
Hi my name is Monika, i have a Chevy Camaro 98 155,000 miles 3.8 Litre, I was just wondering if anyone could tell me what could possibly be wrong with my car, it'll drive for about 5-8 minutes good then it stall, backfires, and the rev goes down to 0, i took it to a scan test and said i needed to replace the crank and map sensor which i did but it is still doing the same exact thing $730 later Grrrrrrr!!!So if anyone knows whats wrong with it i would REally appreciate the help.

Thank you,
Monika E.
Mar 19, 2007 at 5:03 PM
Avatar
SERVICE WRITER
  • CERTIFIED EXPERT
  • 9,123 POSTS
HEy Monika,

My guess is they told you the codes, but didn't diagnose it. You need to clear the codes and have a crankshft position sensor variation learn precedure done on it since you replaced the sensor. You need a scanner capable of doing this however.
Mar 19, 2007 at 5:18 PM