Camshaft alignment?

2015 VOLVO V40
80,000 MILES • 2.0L • 4 CYL • TURBO • 2WD • MANUAL
Avatar
SEANBYERS
  • MEMBER
  • 3 POSTS
I am on with aligning the camshaft and was told to go by the marks but also have piston 1 at TDC, but on the crank mark it's not TDC do I go TDC, or go by the mark?
Oct 22, 2024 at 12:33 PM
Advertisement
Avatar
STRAILER
  • CERTIFIED EXPERT
  • 53,854 POSTS
Correct, the piston for the #1-cylinder comes up twice, but once one position is correct. If the engine is apart the best way to tell is to have the #1-cylinder camshaft lobes 180 degrees away from the valves themselves. Here are the timing marks to make sure you will get it put back together correctly. For the camshafts timing there is a special tool they use. Here is the crankshaft mark and the tool they use. Check out the images (below). Let us know if you need anything else.
Images (Click to enlarge)
Attached Media
Attached Media
Attached Media
Attached Media
Attached Media
Oct 22, 2024 at 5:22 PM
Avatar
SEANBYERS
  • MEMBER
  • 3 POSTS
Okay, thanks, so I don't want it top dead center I just want it on the marks. thanks
Oct 23, 2024 at 2:58 AM
Advertisement
Avatar
SEANBYERS
  • MEMBER
  • 3 POSTS
Also, is it common for the mark to be slightly off as it's back together now and the left hand cam is off by 1 tooth and crank shaft turns fine, but if I line it up crankshaft will only go 180 degrees.
Oct 23, 2024 at 3:02 AM
Avatar
STRAILER
  • CERTIFIED EXPERT
  • 53,854 POSTS
Can you upload an image so I can see? The marks should be pretty close to spot on.
Oct 23, 2024 at 10:13 AM