After replacing the blend door, the A/C controls do not turn off the front vents?

It sounds like the orientation of the blend door drive is not timed correctly or the actuator is defective. Also, it says to Initiate the Actuator Calibration function using a scan tool, did you do this? Check out the images (below). Please let us know what happens.

Sorry for the delay, I was just able to test the actuators. The scan tool showed everything functioning properly.

Okay, let's remove the actuator and work the blend door pivot by hand when the system is on low to see if you can actuate the door by hand. This guide will show you what I am talking about:

https://www.2carpros.com/articles/replace-blend-door-motor

Please go over this guide and get back to us.

Do I need to remove all the actuators or a specific one?

Just the one you replaced, did the system work okay before you replaced the actuator?

It was still acting up on occasion not switching vents. I did this before I replaced the actuator, I was able to move the door and change the temperature. The actuator I replaced was for the heat control on the driver side.

Okay, then I would go back to moving the driver's side actuator pivot by hand to see if that fixed the problem.

I tried doing it by hand but that only controlled the heat function on the driver's side.

Okay so that works, does the drivers side work okay with the actuator connected? It might be you have a mode actuator that is not working. Lets try the same process for this actuator to see if things change.

I have the center console removed but not seeing the actuator. Can you give more clarity to where it is?

Sure, it looks like it is down low in the middle of the heater plenum. Check out the images (below). Let us know how it goes.

I am still not seeing it. Is it on the front side?

It might be under the plenum. Can you upload some images of what you are seeing?

This is behind the center console and radio.

Hmm, I don't see it either, does this truck have dual zone climate controls? It might be further under the HVAC plenum, this is all they show for the location.

I found the mode door actuator it was the one by the steering column. I realized it was working properly, but the gear plate it is on is out of alignment. Do you have an image of it in alignment?

Nice work, I found it as well, it is called the mode actuator 2. I don't see the gear you are talking about though. This shows all of the actuators.

Right behind the actuator it has a cover then instead is a plate with slots in it that align to move the doors. I can’t get the alignment right for some reason.

So this is strange, they don't show anything like that, can you give me your VIN so I can look it up that way?

The VIN is 1C6RREFT8LN398293.

I see the truck is a hybrid. Here are the instructions for the blend door and the linkage, this should help. Check out the images (below). Please let us know what happens.