ABS module

2005 PONTIAC MONTANA
203,000 MILES • 3.4L • 6 CYL • 2WD • AUTOMATIC
Avatar
MATTHEW MARCUM
  • MEMBER
  • 42 POSTS
I'm working on the vehicle listed above and it has been messing up since I got it. So my question is, how do I disconnect the ABS because there is no main fuse under the hood.
Sep 7, 2019 at 2:35 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
Good evening,

Did you check for codes for the system? Most of the time, it is just a sensor.

You can disconnect the wire harness from the module. I would look to repairing it as it is a safety feature.

Roy


Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

1. Turn the ignition switch to the OFF position.
2. Remove the air cleaner housing from the engine compartment.
Images (Click to enlarge)
Attached Media
Attached Media
Sep 7, 2019 at 6:33 PM