can i reset my tire pressure light on my 2010 maxima
Jul 24, 2011 at 1:47 PM
tire pressure light
2010 NISSAN MAXIMA
KOBERRY
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Try this.
TPMS RESET -- PROCEDURE 2
Locate small single wire connector about 2 inches behind the 16 pin OBD II connector on the same harness. With ignition off ground the single wire, then turn the ignition to the run position. At this point momentarily un-ground and ground this wire 5 times in ten seconds. If done successfully the TPMS lamp will start to flash, remove jumper wire and start engine. Light will continue to flash.
Now you have two options :
1. with the reset tool starting with the left front working clockwise trigger each sensor this is the recommended way
2. or simply drive the vehicle over 50kmph until the lamp stops blinking and goes out. Be aware this drive method can take over 10 min.
TPMS RESET -- PROCEDURE 2
Locate small single wire connector about 2 inches behind the 16 pin OBD II connector on the same harness. With ignition off ground the single wire, then turn the ignition to the run position. At this point momentarily un-ground and ground this wire 5 times in ten seconds. If done successfully the TPMS lamp will start to flash, remove jumper wire and start engine. Light will continue to flash.
Now you have two options :
1. with the reset tool starting with the left front working clockwise trigger each sensor this is the recommended way
2. or simply drive the vehicle over 50kmph until the lamp stops blinking and goes out. Be aware this drive method can take over 10 min.
Jul 24, 2011 at 2:04 PM