Engine wont start

2010 JEEP LIBERTY
132,000 MILES • V6 • 4WD
Avatar
PUDDINCUP08
  • MEMBER
  • 4 POSTS
Drive it fine shut off for 5 mins and then wont start just keep turning over..about 20 mins later starts right up.
Nov 25, 2019 at 5:33 PM
Advertisement
Avatar
STRAILER
  • CERTIFIED EXPERT
  • 53,854 POSTS
Hello,

Do you have a check engine light on? If so lets run the codes to see what comes up. here is a guide to help us:

https://www.2carpros.com/articles/checking-a-service-engine-soon-or-check-engine-light-on-or-flashing

When it stalls, turn the key to the on position without cranking the engine over can you hear the fuel pump run in the tank for 5 seconds?

It sounds like the crankshaft position sensor is going out here is the location so you can check it out.

Check out the diagrams (below). Please let us know what you find. We are interested to see what it is.
Nov 26, 2019 at 6:33 PM
Avatar
KASEKENNY
  • CERTIFIED EXPERT
  • 18,907 POSTS
This sounds like a crank sensor is failing. I attached a guide that talks about this a little more.

https://www.2carpros.com/articles/symptoms-of-a-bad-crankshaft-sensor

I would suggest changing the cranksensor and go from there. This is pretty common when these get hot they go to an open circuit and then when they cool back down they starting working again.
Nov 26, 2019 at 6:38 PM
Advertisement
Avatar
PUDDINCUP08
  • MEMBER
  • 4 POSTS
we changed that ..didn't do it for like 3 weeks then started back..
Nov 27, 2019 at 1:00 PM
Avatar
KASEKENNY
  • CERTIFIED EXPERT
  • 18,907 POSTS
How often did it do it before you changed it? Was it doing it every day or did it go weeks between incidents? Also, where did you get the sensor? Was it a Mopar sensor or just a local parts store?

I am looking to narrow down whether that made a change because it was acting up all the time and then it started again or it really didn't change anything because it didn't act up that often.
Nov 27, 2019 at 4:02 PM
Avatar
PUDDINCUP08
  • MEMBER
  • 4 POSTS
Didn't change anything..
Nov 27, 2019 at 9:33 PM
Avatar
KASEKENNY
  • CERTIFIED EXPERT
  • 18,907 POSTS
Okay. If you changed the crank sensor and it did not change anything then we need to check for codes and see if we have anything that will point us to the issue. If we don't have codes then we need to get it acting up and check for spark and then fuel by spraying starter fluid in the intake to see if it fires.
Nov 30, 2019 at 7:22 PM
Avatar
PUDDINCUP08
  • MEMBER
  • 4 POSTS
No codes have showed up checked those too. When it does act up it only has 20% gas pressure.
Dec 1, 2019 at 9:24 AM
Avatar
STRAILER
  • CERTIFIED EXPERT
  • 53,854 POSTS
It looks like you found the issue a bad fuel pump. here is how you change it out. This guide will help walk you you through the steps with diagrams below to show you how on your car. I would get the pump from RockAuto

https://www.2carpros.com/articles/how-to-replace-an-electric-fuel-pump

This video will show you how to drain the tank:

https://youtu.be/Q5MH2gnyFH0

Check out the diagrams (below). Please let us know what happens.



Dec 1, 2019 at 12:36 PM