My headlights are not working why?

2009 CHRYSLER PT CRUISER
30,000 MILES
Avatar
SHARKEYGUY82
  • MEMBER
  • 1 POST
My friend just bought a 2009 Chrysler PT Cruiser and he called to see if i know why the headlights are not working please help us figure this out?!!
Jan 7, 2013 at 3:12 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
Hi,

The headlamps may not be working for a few reasons. For example, a faulty switch, power supply, or the bulbs are bad.

If they all stopped working at the same time, then I would suggest checking power.

This vehicle has a totally integrated power module (TIPM). These are known to have issues with the connector pins for failure due to corrosion or breaking. What I would suggest first is to check for power at the headlamps themselves. If there isn't any, then test at the TIPM.

Here is a link you may find helpful:

https://www.2carpros.com/articles/how-to-check-wiring

If you look at the attachments, they show the entire wiring schematic for the headlamps. I had to cut them in half to make them readable, but I did overlap them so you can follow.

Let me know if this helps or if you have other questions.

Take care,

Joe

See pics below.
Jul 10, 2021 at 11:33 PM
Avatar
AGGIE
  • MEMBER
  • 1 POST
My car runs great. It doesn't try to stall dead or anything like that. However, it does have one problem while driving. The headlights will turn off or flicker sometimes even the dash once they both went out and then came right back on.
Thank you for your time.
Jul 28, 2021 at 2:46 PM (Merged)
Advertisement
Avatar
JACOBANDNICKOLAS
  • CERTIFIED EXPERT
  • 110,175 POSTS
Hi,

If you look at the attachments below, they provide the fuse box orientations and what each fuse is for.

In addition to just checking a fuse, make sure there is power to it. A fuse may be good and not be receiving power.

Here is a link that you may find helpful when testing:

https://www.2carpros.com/articles/how-to-check-a-car-fuse

I hope this helps. Let me know if you have additional questions.

Take care,

Joe

See pics below.
Jul 28, 2021 at 2:46 PM (Merged)
Avatar
BRTODD
  • MEMBER
  • 1 POST
The left light went out replaced with a new bulb and didn't work now don't have low beams on either side what could it he
Jul 28, 2021 at 2:46 PM (Merged)
Avatar
JDL
  • CERTIFIED EXPERT
  • 16,098 POSTS
If the new bulb didn't work, I'd check voltage and ground at the headlamp connector. Also, could be something going on with dimmer switch. Note the diagram. See the beam output, right/left, high/low. in the integrated power module, those wire colors are voltage. The ground for the headlamps is black.

There are trouble codes for the lamp circuits. Some of the national brand auto stores used to check codes for free. These are B type codes.
Jul 28, 2021 at 2:46 PM (Merged)