2008 DODGE CHARGER
75,000 MILES
Avatar
RICHARDVEGA
  • MEMBER
  • 2 POSTS
I recently change the water outlet on my 2.7 liter I had to remove the upper manifold to be able to put the new water outlet after I had change the part I notice my heater also. Is not working did I do something wrong ?
Nov 14, 2012 at 1:35 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
klthe heater doesnt' work meaning what? no hot air? what temp stat is it and was it installed correctly?. does the blower not work? check fues and relay s in underhood fuse box.
Nov 14, 2012 at 3:01 PM
Avatar
RICHARDVEGA
  • MEMBER
  • 2 POSTS
Yea the heater no hot air , plus my temp needle isn't working also ! I'll check the fuses doh to make sure their ok. What blower to be exact? Yea the water outlet only had four screws which I change because it had blown anti-freeze all over it! I'm pretty sure I did correctly but I'll double check just in case.
Nov 14, 2012 at 4:11 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
ok check both hoses for being hot first with engine warm. if they are then it's an internal heater problem. Ther ei sonly one blower for the heater an dthat moves the air does it work? ifyu arenot getting hot air with the hoses hot then it's an actucator problem with the heater box, either it's vacuum or not getting power or not working. pic inclosed fo actuator for your car. there should be 2 and they are interchangeable. however if you are not gettin gpower to them you should have it scanned to see if there is anything wrong with the controlpanel.
Nov 14, 2012 at 5:49 PM