2007 Dodge Magnum Serpentine belt tension arm pulley

2007 DODGE MAGNUM
85,000 MILES • 2.7L • V6 • AUTOMATIC
Avatar
TONE KAPONE
  • MEMBER
  • 4 POSTS
My serpentine belt tension arm pulley has melted down and I need to change it. The wheel is facing inward towards the engine though, and it eaves no room for any tool to get to the bolt holding the wheel to the arm. How do I take out the wheel and put in a new one?
Image (Click to enlarge)
Attached Media
Aug 23, 2014 at 7:37 AM
Advertisement
Avatar
WRENCHTECH
  • CERTIFIED EXPERT
  • 20,761 POSTS
You remove and replace the whole tensioner.
Aug 23, 2014 at 12:08 PM
Avatar
TONE KAPONE
  • MEMBER
  • 4 POSTS
Can you give me step by step instructions on how to do this properly. Please!. Cause somebody told me the spring in the tensioner can pop out and hurt someone bad.
Aug 23, 2014 at 1:38 PM
Advertisement
Avatar
WRENCHTECH
  • CERTIFIED EXPERT
  • 20,761 POSTS
It will not come apart. Just remove the one center bolt. https://www.2carpros.com/images/external/131064625.jpg
Aug 23, 2014 at 1:42 PM
Avatar
TONE KAPONE
  • MEMBER
  • 4 POSTS
Please!!
Aug 23, 2014 at 1:42 PM
Avatar
TONE KAPONE
  • MEMBER
  • 4 POSTS
Thank you so much then, I will give it a try.
Aug 23, 2014 at 1:44 PM