2006 suzuki reno Cylinder 1 and 4 misfire

2006 SUZUKI RENO
68,000 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
CBLACK3
  • MEMBER
  • 2 POSTS
I recently just had to replace the engine in my 2006 reno at 65000 miles, upon having a used engine with 68000 on it, the check engine light has not turned off. I got the codes ran and it says cylinders 1 and 4 are misfire. Had the ignition coil replaced did nothing, removed the valve cover found out the shop put it champion spark plugs so i replaced them with the right ones (ngk) Nothing. The check engine light stays on all the time but everytime the car exceeds 60mph the light starts to flash. I turn the car off and restart it, and it stops, tested it again, drove its for 30 mins at 55 mph no flashing, but as soon as i gassed it over 60mph in about a minute it started flashing again, any ideas, the engine has only been in for less than a month, sounds great but gas mileage is extremely below normal and car seems to struggle with power. Really could use some help...
Jan 29, 2011 at 6:26 AM
Advertisement
Avatar
RASMATAZ
  • CERTIFIED EXPERT
  • 75,992 POSTS
Check the those cylinders compression and injectors, test the coil/s and the crankshaft position sensor
Jan 29, 2011 at 6:38 AM
Avatar
CBLACK3
  • MEMBER
  • 2 POSTS
Well the New coil was put in 3 days ago and i have no codes popping up for the crankshaft position sensor, is it possible it could fail without a code?
Jan 29, 2011 at 7:42 AM
Advertisement