thermostat replacement

2006 KIA SPORTAGE
98,000 MILES • 2.0L • AUTOMATIC
Avatar
CASEY269
  • MEMBER
  • 1 POST
Where do I find the thermostat and what do I have to remove to get to it. I don't know if is the top hose or the bottom hose . If it is the top hose I will have to remove stuff ( WHAT?). the car dose not heat what else could it be and would i find it and can i check it without having to bur something.


Jan 15, 2014 at 8:18 AM
Advertisement
Avatar
STRAILER
  • CERTIFIED EXPERT
  • 53,854 POSTS
Hello,

The thermostat is located at the end of the upper hose toward the engine.

Here a video on the job.

https://youtu.be/EOv72WPf7Mo

Here is a guide that will give you an idea of what to do as well.

https://www.2carpros.com/articles/replace-thermostat

Here are some diagrams to help you see what I am talking about for your car I have included both 4 and 6 cylinder engines just in case some one else needs them.

Check out the diagrams (Below). Please let us know what happens.
Nov 8, 2017 at 3:51 PM
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
bad thermostat in my car, live on hot climate, should i remove it for good?
Feb 9, 2021 at 5:44 PM (Merged)
Advertisement
Avatar
CJ MEDEVAC
  • CERTIFIED EXPERT
  • 11,004 POSTS
in order for your engine to run efficiently the computer must recognize a constant operating temperature removing the thermostat might keep the engine "too cool"---the computer might remain in "closed loop" this is sorta a quick explanation of the loops there are two "loops"---"open" and "closed" open means the sensors are giving the computer "real time" info, example: o2 sensor is telling the computer the oxygen content in the exhaust so it can adjust the injectors to get the most efficient "burn" possible being that it takes a little while for the o2 to warm up to "transmit" info...how does the engine run? same goes for "temperature sensors---it must get to operating temperature before it is "sensed" by the computer the engine runs "closed loop" during the time it awaits for sensor to "come on line"---which means the computer has "preset" values programmed into it--it runs off of them, until all sensors come on-line.....closed loop sorta means, the engine components are "fed false info", that will make the engine run---this "loop" is not efficient, usually you will notice it runs rich--mpg goes down!

this is not only true for the o2 sensors, but other sensors not working will cause this (staying in closed loop)---closed loop is basically "default"

"open loop" is when the computer runs the engine off of "right now!"--"real time" information----basically the present environment is being sensed by the computer---barometric pressure/ oxygen content in the fuel/ engine temperature/ air movement into the engine/ etc...etc. with this info, the computer does not rely on "preset/ default" information to make inefficient "fuel decisions"----it can now use the "present environmental info" to make efficient fuel decisions giving your vehicle peak performance

the medic
Feb 9, 2021 at 5:44 PM (Merged)
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
Do you have to have a thermostat? Will it run hot with out it?
Feb 9, 2021 at 5:44 PM (Merged)
Avatar
2CP-ARCHIVES
  • MEMBER
  • 4,540 POSTS
Yes you should have the thermostat in, you can run it with out thermostat too, but the issue is that will run rich using a lot of gas and it will effect the emission system.
Feb 9, 2021 at 5:44 PM (Merged)
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
removing it will not cause car to overheat. it should run cooler in fact. in warm climate it should not cause excessive gas useage.
Feb 9, 2021 at 5:44 PM (Merged)