pressure plate off of the fly wheel?

it needs to be unbolted from the flywheel. normally the clutch dic and pressure plate are replaced as a set.

i know that but this one has another plate that goes pressed on the fly wheel its a 2006 dodge ram 2500 5.9 cummings diesal 4wdr

i can't get into my manual at this time to show you a pic i'll try to answer later.

this is a dual lfywheel set up and there are bolts that holde the second flywheel so the inner disc will come out. this has to be done correctly on install or it will screw up the disc.i'm not real sharp on clutches of this type not having done many. It's very important to have the pressure plate reset as it will cause the disc to fail again. I can't find any pics to send to you other than a typical setup as that is all we have.
On the back side of the housing attached to the engine block is a cover. Located on the passasger side. Take the cover off and you will see bolts like a automatic torque
converter bolts. They are eight bolts to unscrew.
The dualmass flywheel will come out from the flexplate.