2005 Toyota Sequoia New engine or fix

2005 TOYOTA SEQUOIA
194,000 MILES • 2.2L • V8 • 2WD • AUTOMATIC
Avatar
CDAUTERIVE1
  • MEMBER
  • 4 POSTS
I forgot to change the timing belt a second time and the belt broke now fix but has two bent valves. Should put a use 360000 mile engine cost 4600. Body and inside I'm great condition. What should I be concerned about if I swap the engine? Any advice would be great.
Jul 13, 2015 at 8:27 PM
Advertisement
Avatar
CARADIODOC
  • CERTIFIED EXPERT
  • 34,306 POSTS
Why replace the entire engine? Just have the bent valves replaced. The price you listed, if that was $4,600.00, is way too much for any engine with such high mileage.
Jul 13, 2015 at 9:11 PM
Avatar
CDAUTERIVE1
  • MEMBER
  • 4 POSTS
i made a mistake the engine has 36000 not 360000. Is cost about 2500 to fix the valves.
Jul 14, 2015 at 6:36 AM
Advertisement
Avatar
CARADIODOC
  • CERTIFIED EXPERT
  • 34,306 POSTS
That's better, but it is still overkill to replace the entire engine, especially when the same thing can happen to that one. I'd seek a second opinion on the cost. I realize special tools are needed to do valve work on Toyotas, but I'd expect this to cost about half of what you listed.
Jul 14, 2015 at 1:13 PM
Avatar
CDAUTERIVE1
  • MEMBER
  • 4 POSTS
so, in your professional opinion, you think I should just have the valves replaced and continue to just maintain as usual once done?
Jul 15, 2015 at 11:18 AM
Avatar
CDAUTERIVE1
  • MEMBER
  • 4 POSTS
do you mean half of 2500?
Jul 15, 2015 at 11:19 AM
Avatar
CARADIODOC
  • CERTIFIED EXPERT
  • 34,306 POSTS
Yup. About half of the engines out there are of the interference type that can develop bent valves when the timing belt breaks, jumps a few teeth, or is replaced and proper procedures aren't followed. It is customary on those to replace the bent valves and install a new timing belt. The only time the entire engine is replaced is when a piston gets damaged from hitting the valve, but that is very rare.

It is also pretty common on all engines with cast iron blocks and aluminum cylinder heads for the head gaskets to leak, either due to corroded gaskets or warped heads. The same repair is involved in replacing a head gasket. The only difference is while your head is off, the valves will be replaced too. As I recall, a typical head gasket job for a four-cylinder engine used to run around $500.00 to $800.00, but that was in the late '90s. It will take a couple of more hours to replace the valves, plus the cost of the valves, then most mechanics are going to want to have the head checked for cracks and warpage. That might involve taking it to an engine machine shop. Don't hold your mechanic to this, but I'm suspicious the entire job should run around $1500.00 to perhaps as much as $2000.00.

Make a note of the mileage. Once you have the car back and the engine is running properly, have the timing belt replaced again in another 75,000 miles unless Toyota has a different recommendation.
Jul 16, 2015 at 8:53 PM