transmission and drive shaft connections

2005 KIA AMANTI
6 CYL • 2WD • AUTOMATIC
Avatar
MWDIERKS
  • MEMBER
  • 5 POSTS
The center shaft assembly on the passenger side came out from the tranmission, when I removed the engine. I have tried to put it back in but it's about a 1/4 out so the mounting support won't match up. Any suggestion?
Aug 6, 2011 at 7:05 PM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
Your torque converter has come out, you will have to align the splines and pump drive, best way is to support converter with one hand and gently spin and apply pressure this will normally align all shafts and it will pop back in, it may take a time just go gently and be patient.
Aug 7, 2011 at 12:22 PM
Avatar
MWDIERKS
  • MEMBER
  • 5 POSTS
This is not the torque convert. I had the passenger side axle come out. I have matched the gears up and pushed it in but it's not going in all the way. There is a axle bearing/support that I can not get to its mount on the back of the motor.
Aug 7, 2011 at 1:56 PM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
take the bracket off the engine and tap it back over the bearing, there should be a large clip to hold the bearing in, have not seen one for a while just working on memory.
Aug 7, 2011 at 2:04 PM