How Do I replace the Speed control switch for my heat and air?

2005 HYUNDAI SANTA FE
90,000 MILES
Avatar
KADI
  • MEMBER
  • 5 POSTS
Blower wasn't blowing. I checked the resitor. Then I played with the conrtol ****. just tuning the **** doesn't work. But if I pull or push the whole **** up or down then the blower comes on just fine. I read in my repair book that I have to disarm the airbags befor I pull the panel out and to use either a plastic tool or a taped screwdriver to get the clips open. Is this all I correct and are there any other precausions I need to be aware of?
Nov 25, 2011 at 8:51 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
the control switch is a rare failure. the blower resistor is much more common. how did you check the resistor??

Roy
Nov 28, 2011 at 12:04 AM
Avatar
KADI
  • MEMBER
  • 5 POSTS
We pulled apart the dash and checked the resistor and it was fine. If we pushed the **** past the high postion then it would come on. It also works in the second speed postion but not on any other settings.
Nov 29, 2011 at 12:57 AM
Advertisement