MAP sensor location

Here are the locations for both a 2.3L engine or a 3.0L. Check out the diagrams (below). Please let us know if you need anything else to get the problem fixed.

Cheers

Pulled a P0106 code, I was told the map sensor needs to be replaced. I have a four cylinder 2.3L and I am not entirely sure where the MAP sensor is or what it looks like. I am trying to purchase a replacement one. Thanks.

I had my vehicle scanned due to idling problem and the result is Manifold Absolute Pressure/BARO Sensor High. Please help in locating the MAP Sensor.

This car has a MAP and MAF sensors. Here is a guide to help you with the MAF and a diagrams below that shows the MAP location:

https://www.2carpros.com/articles/how-to-replace-a-mass-air-flow-sensor-maf

Check out the diagrams (below). Please let us know if you need anything else to get the problem fixed.

USER NOTES: If this is a 2.3 then the oil filter is in the wrong place, I have a 2008 hybrid 2.3, I have changed the oil filter several times, any that filter is on the front of the motor, not the back as displayed here

Noted with thanks. Do you know the Ford MAP Sensor part number and pictures or drawing of this MAP Sensor?

OEM part number: 4S4Z9F479AA. However, there are plenty of aftermarkets out there probably cheaper.

Thanks guys for the help. Appreciate it.

Already replaced the MAP sensor with surplus MAP sensor and no more error code in the scanner. However, the idling problem still persist. What do you think is the problem? Erratic idling, rough idle when car is stationary. Car strong vibration at idle and sound skipping.

Need location of the sensor.

If you have an EGR valve check to see if it may be stuck open with a chunk of carbon or something. Make sure it is not being activated at idle.
Check your fuel pressure for leak down after shut off for possible injector leak.

This guide can help.

https://www.2carpros.com/articles/engine-vibration-at-idle

Hello,

Your car does not have a MAP sensor it has a MAF sensor which is located near the air filter housing.

Here is a a couple of guides and some diagrams (below) to help you locate it:

https://www.2carpros.com/articles/how-a-mass-air-flow-sensor-works-maf

and

https://www.2carpros.com/articles/how-to-replace-a-mass-air-flow-sensor-maf

Please let us know if you need anything else to get the problem fixed.

Cheers, Ken

Noted with thanks. We will try it out and keep you posted. By the way is there a idle air control valve sensor on Ford Escape 2007 XLS 2.3L gas?

Yes, it does.

Thanks for the guide. My car had low compression in number two cylinder so I had to do a valve job cost me $1,400.00.

Where is the MAP sensor located?

It is plugged into the intake manifold. There is an emissions sticker under the hood that shows the vacuum hose routing. The MAP sensor should be shown on that.