How do I change the high flow sensor/ solenoid on my 2003 Saturn vue?

2003 SATURN VUE
14,500 MILES
Avatar
KATCANDEUX
  • MEMBER
  • 2 POSTS
Trouble code says it is a high flow purge issue. Mechanic pressure /smoke tested for leaks and believes it to be the sensor solenoid. I can see the sensor but I don't know what to remove so I can reach it. Does the quick connect require a special tool for removal?
Dec 2, 2011 at 5:44 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
What size engine do you have?Also what is the exact code number the vue is settng?Also where is this part?Because from what your calling it i have no clue what oart your talking about.
Dec 2, 2011 at 6:41 PM
Avatar
KATCANDEUX
  • MEMBER
  • 2 POSTS
The code reads P0496 evaporative emission system high purge flow. The part looks like a small canister-about the size of a 35 mlm roll of film. There is a length of tube with quick disconnects on both ends of the canister.

The part is located close to the dash wall just behind the engine block. It is a v6 3 ltr automatic
Dec 2, 2011 at 8:33 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
I belive there is a little tab you push to the side to release the hose then pull the hose off.Before replacing it see if you can blow thru it if you can thenits stuck open.If you cant blow thru it then its probably not the problem.Did they ever remove the gas with the key in the run position engine off and see what the fuel pressure sensor was reading?
Dec 3, 2011 at 1:52 AM