2003 Mitsubishi Eclipse cv axle

2003 MITSUBISHI ECLIPSE

150,000 MILES • 3.0L • 6 CYL • FWD • MANUAL

ETIDE30

MEMBER
3 POSTS
FOLLOW

installed cv axle, still making vibration noiste when turning wheel to right even slight turn at high speeds. replaced bearings already. is it possible the cv went to far into tran? also is normal for cv joints to stretch out when connecting axle flush to hub wit axle nut? also this is a non abs vehicle would the ring on the axle for abs cause the vibration? stumped mechanic said bearing the other day but i replaced it twice moog bearing. please help

Mar 13, 2015 at 9:21 AM

HMAC300

CERTIFIED EXPERT
48,601 POSTS

this cold be almost anything including tires. try moving front tires to rear first as it may be a tire issue. as far as the axle goes there is a snap ring on it and it should have snapped in place when you installed it so it doesn't go in to far. also the boot will stretch some because suspension was dropped down when it was installed. it does the same when you turn as well. it may also be a brake problem or maybe front end bushings.

Mar 13, 2015 at 9:29 AM

ETIDE30

MEMBER
3 POSTS

for responding. already switched wheels, sorry left that out , i even replaced rotor, the axle went into the first part of tran had to hammer in rest of way did not hear a click it looks pretty flush with tran as far as i can see

Mar 13, 2015 at 9:35 AM

HMAC300

CERTIFIED EXPERT
48,601 POSTS

well it could also be something else entirely as well check motor/trans mounts and front suspension. Other than that I can't think of anything else.

Mar 13, 2015 at 9:52 AM

ETIDE30

MEMBER
3 POSTS

is it possible i pushed the cv in to far

Mar 13, 2015 at 9:58 AM

HMAC300

CERTIFIED EXPERT
48,601 POSTS

I really don't think so but if you think It is try pulling it out a little and see if it will move, if not then it's locked in to position. Of course it could be the wrong axle. as one side may be different from the other.

Mar 13, 2015 at 1:06 PM