2003 JEEP LIBERTY
65,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I have jeep liberty 3.7 2003 just got it.After starting it up it runs for about 6 to 8 minutes and shuts off than starts up again no problem runs again for few minutes and shuts off again,My noticing is warmer it gets shorter it runs.When l drive it runs awesome but then it stalls on red light or when l slow down to make a sharp turn.I have cleaned throttle body and changed IAC,TPS,camshaft sensor previous owner changed spark plugs,air filter and put new batery in.I am about to change my fuel filter is there anything else that needs to be done.
Dec 15, 2012 at 11:36 PM
Advertisement
Avatar
ASEMASTER6371
  • CERTIFIED EXPERT
  • 52,796 POSTS
stop throwing parts at it till you know the issue. you are wasting money.

check fuel pressure.

is the check engine light on??

need to check spark as well.

Roy
Dec 15, 2012 at 11:41 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
ignition parts can fail when heated. any codes come up?
Dec 15, 2012 at 11:45 PM
Advertisement
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
crank sensors are known culprit with these.
Dec 15, 2012 at 11:47 PM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
also that yr had a TSB requiring PCM to be FLASHED with new intructions set. the issue was stalling.
Dec 15, 2012 at 11:57 PM