2003 Ford Excursion wont start

how did you check the FICM??? what scanner did you use???

what is the oil pressure from the high pressure pump while cranking???

Roy

Roy,

I tested it with my multi meter. I pulled the window off and put my negative lead to a ground and put my positive lead to the screw that was in the row of four closest to the passenger side. With the key in the on position I was getting readings of 48 and when I was cranking the motor the reading where the same.
Its not throwing any codes so my scanner isn't getting anything and I don't have a tester to test pressure. I was going to try to turn it again and watch the pressure gauge and see if it jumps up. If that the case would that indicate that there is at least enough low pressure to start it?

Ty

the high pressure oil pump feeds the injectors. your gauge will not read it. you need a scan tool capable of reading the pressure. it needs to be at least 700 lbs.

Roy

could the ICP be a reason this is happening too?

yes, that or the connector have high failure rates.

a scan tool will confirm instead of guessing.

Roy

If its good whats the next step?

and

If it is bad what is the next step?

I will go get a scanner

By the way thank you Roy this is helpful up to this point

you need to verify high pressure oil pump first.

Roy

I will be doing that today. Can you tell me where I can find the proper readings for everything and. I know the high pressure need to be at least 700 psi

let me see what I can find for you

Hve you had any luck with that

when you get your scan tool make sure you do a buzz test on all injectors.


Roy

Will do, what reading will I be looking for ?

700 lbs on the high pressure pump and you should hear the injectors loudly one at a time

Roy