2003 Chrysler Sebring Re-assembly after timing belt change

2003 CHRYSLER SEBRING
3.0L • V6 • 2WD • AUTOMATIC
Avatar
MALDITOTE1
  • MEMBER
  • 1 POST
Long story short, I replaced the water pump and timing belt on my car using a Haynes manual. Unfortunately I didn't take "before" pictures and now I don't remember how the crankshaft position sensor wiring is routed so it doesn't interfere with the timing belt. Also, I don't remember if the timing belt covers are installed before the engine mount bracket. Please help.

Thank you,

JR

P.S. I love your website. Keep up the good work. Great pics & diagrams.
Mar 28, 2014 at 7:23 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
Loosen tensioner pulley center bolt. Position tensioner pin holes at top of tensioner.
Install engine support bracket on engine block. Tighten top bolt first, then working in a counterclockwise direction, tighten the remaining bolts. See Fig. 6. Install timing belt covers. Install crankshaft pulley. Apply engine oil to crankshaft pulley bolt, then tighten bolt to specification. See TORQUE SPECIFICATIONS.
To install remaining components, reverse removal procedure. Adjust drive belts to proper tension.
we don't have any pics of the routing of crank sensor you are looking for sorry
Mar 28, 2014 at 7:30 AM