2002 MITSUBISHI LANCER
Avatar
STRYKERJ
  • MEMBER
  • 3 POSTS
Turn lights and hazard lights stopped working after replacing new headlight assembly
Nov 15, 2012 at 12:49 AM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
Have you chekd the fuses?
Nov 15, 2012 at 6:19 PM
Avatar
STRYKERJ
  • MEMBER
  • 3 POSTS
yes
Nov 15, 2012 at 7:22 PM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
Are they ok? What did you do when replacing the headlight?
Nov 15, 2012 at 7:26 PM
Avatar
STRYKERJ
  • MEMBER
  • 3 POSTS
We disconnected the three plugs and unscrewed the headlight assembly for each headlight we pulled them out and snapped the bulb in for the new ones screwed them in and attached the cords. One of the cords was not connecting right but we fixed it so the side lights would both work and the headlights work but when went to check the turn signals nothing happened. We popped open the fuse next to the battery and checked them finding that hazard fuse was bad so we replaced it. We checked again but nothing so we checked the fuses under the steering wheel and nothing seemed wrong with them either. We rechecked the wires on the headlights nothing seemed wrong.
Nov 16, 2012 at 7:04 AM
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
After replacing the hazard fuse, did you recheck if it is blown again? The headlight replacement could have caused a short to the turn signal circuits.
Nov 16, 2012 at 10:41 AM