heater blowing cold air

2002 MITSUBISHI GALANT
65,000 MILES
Avatar
LARRY COLLETT
  • MEMBER
  • 1 POST
the heater core hoses are cold, but engine is fully warm...is there a valve motor which controls fluid flow or something electrical, or is the core just clogged
Feb 29, 2012 at 1:44 AM
Advertisement
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
The heater control valve motor is located below the dash on the passenger side. First remove the glove box, then the lower trim panel. Before removing the lower trim panel remove the center trim around the radio and A/C controls. After removing the lower trim panel, the heater control valve motor is on the left side underneath the automatic compressor controller, connected to the heater control unit. if it's the problem you can replace or just manually open.
Feb 29, 2012 at 3:02 AM
Avatar
FIXITMR
  • CERTIFIED EXPERT
  • 9,990 POSTS
check this out. http://www.youtube.com/watch?v=HywkYSNRGug
Feb 29, 2012 at 3:07 AM
Advertisement