Voyager got crazy

I hate to say it, but I feel the PCM may not be working properly. Try this. Disconnect all fuel injectors (remember which one goes to which injector). See if the vehicle will start and run for a few seconds with starting fluid. If it does, chances are a driver in the PCM for the injectors has failed. Also, check fuel pump pressure and make sure it is within spec and check the fuel pressure regulator to make sure that is good. One last thing, check to make sure the spark you are getting is a good hot blue snapping spark. If it is orange or white, it won't run the vehicle.

All that you have say has been checked and seems to be ok.
Even we have configure a seconda hand but good working condition ECU with more or less same results.
What seems strage to me is control legend on the dashboard that comes and goes.
Everitime cuise legend comes, engine stalls and fails.....
I know this vehicles are prone to have wiring harnes problems in certain models, but how can I know if front control module or confort control module has gone bad?
Now is it a common fail for this ecu´s to have problems with the injector drivers?
Regards
Ray

Although it isn't a common problem, the drivers in the PCM do go bad. NOTE: I am basing it on the concept that the injecter pulse is out of spec as you described. It could require something as a reboot that needs to be done by a dealer. I'm not sure what you mean by confort control module. There are several control modules in the vehicle, but the power control module is what takes care of the injector. Make sure the wiring harness is tight, clean, and none of the pins have been pushed back causing a problem. Also, make sure all grounds are good.