timing Settings Chev tracker 2000 2.0 liter

Install scan tool. Start and warm engine to normal operating temperature.
Ensure A/C is off, transmission is in Neutral (M/T) or Park (A/T), and parking brake is fully engaged.
Connect an inductive timing light to ignition coil No. 1. Using scan tool, select special functions, and then engine output controls.
Using scan tool, turn fixed spark mode on.
Observe spark parameter. Scan tool should display 5 degrees, indicating fixed spark mode has been activated. Using timing light, ensure crankshaft pulley mark aligns with timing pointer, indicating timing is correctly set at 5 degrees BTDC.
If ignition timing is 4-6 degrees BTDC, ignition timing is okay.
If ignition timing is not 4-6 degrees BTDC, go to next step.
To adjust ignition timing, loosen Camshaft Position (CMP) sensor housing bolt.
To advance ignition timing, rotate CMP sensor housing clockwise.
To retard ignition timing, rotate CMP sensor housing counterclockwise.
Recheck ignition timing. Readjust ignition timing as necessary.
Tighten CMP sensor housing bolt to 11 ft. lbs. (15 N.m).
Using scan tool, turn fixed spark mode off.
Using timing light, ensure crankshaft pulley mark and timing pointer indicate 12-16 degrees BTDC

What is the make and model of the scanner?I need one.I bought the vehicle with 175,000 miles on the original chains,sprockets,guides,and tensioners.I replaced all of it as a kit.I know for a fact that the CPM was moved while the miles were accumilating on the odometer.I have it in a ballpark of the 4-6 degree area(its not 4 or 6...3.95 or 6.01)It runs but I think it could run alot better.

This scanner works great and has all the modern features such as ABS and SRS scanning. You can get a CAN scanner (Controller Area Network) which will work on most cars from Amazon.

Here is a video to show you how:

https://youtu.be/u-4syLc-ifQ