how adjust the valve clearance

Before making adjustments, you need to check and record the clearances of each and every valve.

After recording, remove the shim and measure the thickness with a micrometer.

All shims must be related to each cylinder it comes out from and add the shim thickness to the clearance of the particylinder valve.

Whatever valve clearance you desire is deducted from the total clearance and the balance is the shim thickness you need to fit in.

Usually not all valve would be out of specs so you need only to adjust those necessary.

You would need special tools for pushing the job.

As Roy mentioned, oil pressure and related concerns might cause the problem so you need to check them as well. If the noise is intermittent, it could be from the VVTi control soleanoid due to inefficient oil pressure, a result of clogged oil strainer at bottom of oil pan, If engine is heavily sludged, you would get this problem with intermittent flashing of the oil pressure oil indicator.

WE have an 01 Camry LE, 85K miles with the 4 cyl motor. Not sure the cubic inch but there is only one 4 cyl. At 85K miles we are having the timing belt replaced. Should we have the valves adjusted (250.00) There are no noisy valves, but we understand exhaust valves can tighten. Does this engine have a history of requiring a valve adjustment at this mileage? Thanks. Wad.

My book says no-need until 120,000 miles thereafter if noise is present, check valve clearance and adjust by adjusting shims.

Hello, I'm Danny.

Here is the information you requested. I've attached picture steps below on how to check for a valve adjustment a make valve adjustment repairs on your car. Hope this helps and thanks for using 2CarPros.