Having trouble getting the cable harness back in and neutral safety switch reconnected do u have any suggestions for getting the cables back in?
Apr 5, 2014 at 8:22 PM
2001 GMC Yukon neutral safety switch
2001 GMC YUKON
LEE26
- MEMBER
- 3 POSTS
- FOLLOW
Advertisement
What is your specific problem?
Apr 6, 2014 at 4:34 AM
Getting the shifter reconnected or adjusted in the right position
Apr 6, 2014 at 8:03 AM
Advertisement
The switch rotates to adjust. The easiest way is to adjust from the neutral position and then test it in Park.
Apr 6, 2014 at 8:36 AM
The switch isnt rotating?
Apr 6, 2014 at 8:58 AM
Park/Neutral Position Switch Adjustment
Adjustment Procedure
Important:
Apply the parking brake.
The engine must start in the P (Park) or N (Neutral) positions only.
Check the switch for proper operation. If adjustment is required, proceed as follows:
Place the transmission range selector in the N (Neutral) position.
With an assistant in the drivers seat, raise the vehicle. Refer to Vehicle Lifting.
Loosen the park/neutral position switch mounting bolts.
With the vehicle in the N (Neutral) position, rotate the switch while the assistant attempts to start the engine.
Following a successful start, turn the engine off.
Notice: Refer to Fastener Notice in Service Precautions.
Tighten the bolts securing the switch to the transmission.
Tighten the bolts to 25 Nm (18 ft. lbs.) .
Lower the vehicle.
Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only.
Replace the park/neutral position switch if proper operation can not be achieved.
Adjustment Procedure
Important:
Apply the parking brake.
The engine must start in the P (Park) or N (Neutral) positions only.
Check the switch for proper operation. If adjustment is required, proceed as follows:
Place the transmission range selector in the N (Neutral) position.
With an assistant in the drivers seat, raise the vehicle. Refer to Vehicle Lifting.
Loosen the park/neutral position switch mounting bolts.
With the vehicle in the N (Neutral) position, rotate the switch while the assistant attempts to start the engine.
Following a successful start, turn the engine off.
Notice: Refer to Fastener Notice in Service Precautions.
Tighten the bolts securing the switch to the transmission.
Tighten the bolts to 25 Nm (18 ft. lbs.) .
Lower the vehicle.
Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only.
Replace the park/neutral position switch if proper operation can not be achieved.
Apr 6, 2014 at 9:11 AM