location of Crankshaft sensor

Hello,

Here is a guide that will walk you through the steps and a diagram below to show the location for your car.

https://www.2carpros.com/articles/crankshaft-angle-sensor-replacement

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

I need to replace the sensor, just can't find it's location

on transaxle housing facing flywheel teeth

Electrical problem
1996 Nissan Quest 6 cyl Front Wheel Drive

where is the crank sensor on a 3.0 nissan quest

Crankshaft Position Sensor ECCS Components Parts

ECCS Components Parts

what is the function of the crankshaft position sensor and could replacing it improve gas mileage?

The camshaft position sensor is a magnetic or hall effect sensor, this sensor reads information about the engine, camshafts and speed. It sends a signal to the computer relaying information about shaft speed, position and acceleration or deceleration. The function of the camshaft position sensor is important for the vehicle to run at its best, and maintaining a high level of performance and fuel economy. The information given to the ECU or the Electronic Control Unit dictates when the air fuel mixture is ignited and when to give more or less fuel in correspondence with the camshaft position, its speed and subsequently the valves position and speed. This is a very simple sensor to replace and service, and yet it serves a huge role in your vehicles performance and overall health.

The Crankshaft Position Sensor provides the reference signal to the PCM for spark and injector pulse and no, it won't effect mileage.

Have 1999 nissan quest 3.3 ,gime the code po1336 crankshaft sensor camshaft sensor range.change crankshaft sensor and reset code still misfire , can any body helpme what it is,or what i need to do.


Thank you for your help

Misfiring is not the same as a set fault for the crankshaft sensor. Was the misfire fault there all along or is it showing up now that the crankshaft sensor has been replaced?

The misfire fault was there all along.

Inspect the ignition components for possible failures. Have the sparkplugs been recently replaced?