2000 Lincoln LS Bad Coolant leak

2000 LINCOLN LS
3.9L • V8 • 4WD • AUTOMATIC
Avatar
JKSOCIAL
  • MEMBER
  • 6 POSTS
Once the coolant leaks and car overheats. Can only drive about half a mile needing more coolant. Terrible leak. Looked around and after checking the top two hoses and seeing that there was still water/coolabt at the bottom of the reservoir, the botton hose was still intact. I found two scratches inside my reservoir that I assume could be the problem. Maybe expanding when I accelerate. Any ideas?
Jul 1, 2015 at 5:52 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
have a pro pressure check for an internal leak like a head gasket.
Jul 2, 2015 at 7:19 AM
Avatar
JKSOCIAL
  • MEMBER
  • 6 POSTS
no. my apologies for not being more descriptive. The leak isn't anywhere near my engine block or disappearing. its leaking. Under the driver side behind the tire.
Jul 2, 2015 at 1:32 PM
Advertisement
Avatar
JKSOCIAL
  • MEMBER
  • 6 POSTS
there are two pictures. from the pictures do it look like it could possibly be the problem
Jul 2, 2015 at 1:33 PM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
i can't really tell form the pics tha tis why I said to have a pro pressure test it. it may possibly be a freeze plug that has gone bad and needs replacing but picture isn't to descriptive. normally on side of block it's a freeze plug
Jul 2, 2015 at 5:02 PM
Avatar
JKSOCIAL
  • MEMBER
  • 6 POSTS
correct. but it is NOT on the side of the block.
Jul 3, 2015 at 6:27 AM
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
freeze plugs can be in cylinder head front, rear, side of block. have a local pro PHSYICALLY check this out.
Jul 3, 2015 at 6:32 AM
Avatar
JKSOCIAL
  • MEMBER
  • 6 POSTS
correct. but again. it is no where near the block. not under, over, or around the block. not even the center of the car towards the front end. only under the driver side behind the front seat, right under the reservoir.
Jul 3, 2015 at 6:36 AM
Avatar
JKSOCIAL
  • MEMBER
  • 6 POSTS
*behind the front tire. I already applied epoxy sealant to the holes, so I will find out in 3 hours.
Jul 3, 2015 at 6:39 AM