2000 Jeep Cherokee fuse blowing

2000 JEEP CHEROKEE
165,000 MILES • 4.0L • 6 CYL • 4WD • AUTOMATIC
Avatar
BUKOWY88
  • MEMBER
  • 2 POSTS
I have a no start situation thatstarted with the engine missfiring and it's blowing the #18 fuse I've replaced cpr sensor Re index the cam sensor and replaced coil pack
Sep 13, 2014 at 11:56 AM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
fuse 18 goes to the horn relay are you sure that is the correct one ? try resetting your security system and check fuel pressure with a gauge autoparts rent it then scan for codes.if no manual look online ot reset security
Sep 14, 2014 at 8:29 AM
Avatar
BUKOWY88
  • MEMBER
  • 2 POSTS
I Dont have book on it so not sure if that is right number for fuse but I do know it is the fuse for coil and fuel.. it has a p0505 code witch is for Iac witch I have replaced witch I understand could be bad connection or loose vac line but I don't think that would be my prob we pulled fuel pump relay and fuse Didnt pop replaced that fuse hasn't pope yet but still running really rough
Sep 14, 2014 at 3:47 PM
Advertisement
Avatar
HMAC300
  • CERTIFIED EXPERT
  • 48,601 POSTS
if you don't know what fuse it is why did you say that one and just give us ether correct info to begin with. You wonder why people write back ticked off. your asd relay is connected to that as well check to see if it's bad you can do that on site here under electrical how to repair. also these engines have a place where harness may wear through at back of head by stud causes problems. also check your fuel pressure it may be low. should be 44-54 autoparts rent gauge. check at idle. its' fuse 22 btw
Sep 14, 2014 at 4:01 PM