3.2 motor

scan for codes first then check to see if to much voltage is going to that coil or one of hte wires are touching the block.

im getting 14 volts to that coil

this really should be checked by apro as this can be an automatich shutdown relay , a bad ground a shorted wire or a bad pcm. it shold only have 8 volts going to it but you need a pro scan tool to check the system because stuff has to be turned off and on with the tool to properly diagnose the problem Your check engine light should be on in this case as well.

check engine light is on and i have a pro scan tool i work in a garage part time so that's why i did the belt myself does code 1652 sound correct?

i don't list that one . the one i looked under was p0353 #3 ignition primary coil circuit. there is a 1682 whichis for charging system to low.