cant find timing mark on crankshaft

1999 VOLVO S70
114,000 MILES
Avatar
SNOWBALL21
  • MEMBER
  • 1 POST
changing timing belt on 2.4 volvo s70. cant seem to find the timing mark on the crankshaft pulley. i set #1 piston at tdc and set the cam gears on there marks but the car still wont start.
Mar 4, 2012 at 4:50 PM
Advertisement
Avatar
KHLOW2008
  • CERTIFIED EXPERT
  • 41,814 POSTS
Refer to diagram for timing marks.
Image (Click to enlarge)
Attached Media
Mar 4, 2012 at 7:17 PM
Avatar
JIS001
  • CERTIFIED EXPERT
  • 3,412 POSTS
There really is no such thing as top dead center anymore on this vehicles anymore. If the timing has been disturbed for any reason then you would need the special tools to lock the cam and crank in there correct timing position to install the timing belt. At this point you may want to take it in to a shop that has those tools and after have a compression check or cylinder leak down test to make sure no valves were bent while it was been cranked over? Hopefully you were not too far off. Good luck to you and hope everything works out.
Mar 5, 2012 at 2:02 AM
Advertisement