on a 1999 vw jetta vr6 2800 eng . does this car need to have the timing set after replacing the thermostat

1999 VOLKSWAGEN JETTA
Avatar
TEXPARTYBOY
  • MEMBER
  • 2 POSTS
i replaced the thermostat on this 2800 eng once i poured a gal of anti-freeze into burp tank the owner of the car started the car up , it made a loud clanking sound like it had bent valves and the car was turned off , the engine will not rotate at all now , the owner clames that another mechanic informed him that i was to set the timing on the eng before starting up the car , is this true and would it be my fault
Dec 18, 2011 at 1:17 PM
Advertisement
Avatar
RASMATAZ
  • CERTIFIED EXPERT
  • 75,992 POSTS
Was it doing that making the clanking noise before you touch the car? I don't think you need to set the timing just to replace a thermostat
Dec 18, 2011 at 2:32 PM
Avatar
F4I_GUY
  • CERTIFIED EXPERT
  • 3,302 POSTS
Although the thermostat is somewhat near the timing chains, you do not have to touch the chains at all to remove the thermostat. Infact, you must remove the transmission to have full access to the timing chains on a VR6.

What is common, is the that chain guides were out and the chain skips and bends valves. This is most likely what happened to your vehicle.
Dec 23, 2011 at 12:36 AM
Advertisement