1999 Toyota sienna rack and pinion

1999 TOYOTA SIENNA
152,000 MILES • FWD • AUTOMATIC
Avatar
MSPONG
  • MEMBER
  • 2 POSTS
I am replacing the rack and pinion assembly on my sienna, the new assembly is in place but I am having a hard time getting the steering U joint to slide onto the new assembly. What is the best way to reattach the steering linkage?
May 16, 2011 at 6:36 PM
Advertisement
Avatar
WRENCHTECH
  • CERTIFIED EXPERT
  • 20,761 POSTS
If you look under the dash, there may be a clamp on the intermediate shaft that when loosened, allows you to slide the shaft up the column a little. It may be using a master spline so it will only slide on in one position. It is very important that you do not allow the steering wheel to turn more than half a turn while disconnected or you will break the clockspring and has an Airbag light on when your finished.
May 16, 2011 at 6:56 PM
Avatar
MSPONG
  • MEMBER
  • 2 POSTS
Thanks for the info. I will give it a try.
May 16, 2011 at 9:49 PM
Advertisement