1999 Saturn SL1 clutch

1999 SATURN SL1
130,000 MILES
Avatar
LALFAN
  • MEMBER
  • 179 POSTS
was working on a saturn sl1. it was always hard to get in gear sometimes, but if u let the clutch out and back in it would go right in gear. now the slave went out and put new assembly and when u put it in gear and give it some gas with the clutch still in it starts to move. doesnt do it everytime but most of the time. it didnt do this before we changed it. i had a used one i tried and it did it and thats when i bought the new one only to do the same. thanks
Jun 4, 2013 at 5:58 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Does the used one you tried move with the clutch pushed all the way in?
Jun 4, 2013 at 6:02 PM
Avatar
LALFAN
  • MEMBER
  • 179 POSTS
yes thats why i bought the new one. but didnt do it with the original one.
Jun 4, 2013 at 6:07 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Did you install the new slave on the transmission with holder for the slave cylinder piston rod in place?
Jun 4, 2013 at 6:14 PM
Avatar
LALFAN
  • MEMBER
  • 179 POSTS
yes it is there to hold it till u push the pedal n break to release it..also wondered if there is anyway to bleed these. i no they come ready to go , but if it ever was low on fluid. thanks
Jun 4, 2013 at 6:24 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
no you don't bleed them that's why they come as a unit.If the hydraulics is working correctly you have a pressure plate issue.Sounds like the pressure plate fingers have worn unevenly causing some of the clutch disc to release and part of it to catch when the clutch pedal is pushed all the way to the floor.I have seen that happen before.
Jun 4, 2013 at 6:40 PM
Avatar
LALFAN
  • MEMBER
  • 179 POSTS
thats kind of what i wondered, but beings it didnt do it till i changed the slave it made me wonder why it just started then.
Jun 4, 2013 at 6:50 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
From the symptoms its a hydraulic issue or pressure plate issue.
Jun 4, 2013 at 7:10 PM
Avatar
LALFAN
  • MEMBER
  • 179 POSTS
ok. thanks for the help
Jun 5, 2013 at 2:00 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Your welcome anytime.
Jun 5, 2013 at 8:09 PM