1999 Saturn SC2 p1671 code

1999 SATURN SC2
145,000 MILES
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
Car started chugging on highway and at one point it just started shifting gears between 2nd & 3rd. went to auto store hooked it on computer and it shows code P1671 ( Quad Driver Module b Quick set detected malfunction) after that turned car on went home and car kept doing the same thing, one hour later went to car and tried to turn car on and did not want to start. What can it be or what can i do cause its been a month and car has not turn on?
Jul 18, 2013 at 3:48 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
So do you have a crank no start or no crank no start?
Jul 18, 2013 at 4:27 PM
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
cranks but doesnt start
Jul 18, 2013 at 4:45 PM
Advertisement
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Have you checked ,for spark yet?Also what about fuel pressure?If you hold your gas pedal all the way to the floor while trying to start it will it start?
Jul 18, 2013 at 6:20 PM
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
yes, am try with the gas pedal all the way down. crank but no start, my wife do one time and i when to the motor to check the gas pressure and was ok, but i no check the spark yet. well i put the spark plug out and check them but look ok for me but i no check the spark yet.
Jul 19, 2013 at 10:04 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Let me know if you have spark when you get a chance.
Jul 19, 2013 at 11:45 AM
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
oki dokie i do....
Jul 19, 2013 at 12:13 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
So you do have spark?What is the actual fuel pressure?
Jul 19, 2013 at 12:16 PM
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
sorry for the delay, am handicap and sometimes is hard for me do thinks. thank for your patience.
well i check the spark on 1&4 and they have a spark, i don't know if u want me to check 2&3.
the person helping me said "if we have spark on 1&4 the crankshaft position sensor is good". we no check the fuel pressure with the proper gauge but when u push the valve came out fuel with rely power. my friend " the one helping me", call some vary else and tell him the problem we have on a car, " the same question i ask you in the begining", and what he said may be can be ignition coils or ignition control module because the same think happen in his car in the same way as me. the mechanic change his computer and the car doing the same, crank but no start, they have spark but the car crank no start, check the fuel pressure was ok, as soon they change de ignition control module the car start and run as never before he said. he have a pontiac 2000 sunfire.. what do you think bout it? can we belive on that?
Jul 23, 2013 at 8:43 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Is it a nice blue spark you have?I would make sure you have spark on both coils?Also I would rule out the ignition module atleast for now.If you have spark on the on coil that means the crank shaft position sensor is working.You also need to check the actual fuel pressure not just it sprays fuel.Have you tried spraying some carb spray in the throttle body to see if it starts up?
Jul 23, 2013 at 5:49 PM
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
well 1&4 had more of a blue spark than 2&3 but did have spark so crank shaft should be ok, but didn't try spraying carb spray in throttle body, so guess i will try again tomorrow and will check fuel pressure
Jul 23, 2013 at 7:54 PM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
Alright sounds Good keep me posted.
Jul 23, 2013 at 8:19 PM
Avatar
MANNY0226
  • MEMBER
  • 7 POSTS
well finally sprayed the starting fluid and its worked. the car turned on for couple minutes, i shut off and then crank but didn't start, Sprayed again and it started. what should I do next?
Jul 28, 2013 at 10:42 AM
Avatar
SATURNTECH9
  • CERTIFIED EXPERT
  • 30,869 POSTS
What is the actual fuel pressure?
Jul 28, 2013 at 4:57 PM