help me plz

what is the issue?? the connector is under the drivers side of the dash

Roy

What model is that and where are you located? For some Asian countries there are no OBD-II connectors even up to 1999 and you need have OBD-II connector for scan tools.

Hello Dear ...
The car is Honda Legend model 1999 and I'm in the Arab Gulf states, where I went to the garage Auto Repair for computer programming work, but unfortunately we did not find place and link a computer if possible attach any image found this link and you very much ...

Check behind the glove box. It most probably is a 2 connector, 3 pin and 2 pin socket type.
2 pin is SCS short connector whereby you can get flash codes by bridging the terminals and turning ignition ON.

Scan tools needs an adapter for the 3 pin DLC socket.

Other areas you should check would be below the radio on either side of center console.

I've seen some of them located on the passenger side, in front of the console and some of them get hidden behind ash trays in the center console.

Well will examine the places and tell you later Thank you

Sorry I could not link to any solution to my problem was examined in the places mentioned but I can not find something and I need to check a computer for the following reasons
- Srs light lit
- Abs light lit
- Hand Break lit light

It should be there, behind the glove box. Did you check at the edges of carpet?

As I mntioned, don't expect an OBD-II terminal.

The OBD2 connector should be right under the left side of the dash.