The dome/map light, rear wiper, key chime or key illumination are not working?

Did this all happen at one time? Can you check for power at the rear wiper fuse? Does the engine start and run? The items you have mentioned are not on the same circuit. The rear wiper fuse is powered by the ignition switch. I would turn the key on and test all fuses for power, here is a guide to help you:

https://www.2carpros.com/articles/how-to-check-a-car-fuse

It seems like many more electrical accessories would not be working if the ignition switch was bad FYI, check out the images (below). Please let us know what happens.

I had the ignition switch replaced; it was stalling the car. The car runs like a top. These problem are happening all at once. I got a new rear wiper motor then I checked and have no power but power on the washer pump.

I'm not a mechanic but sending me on a wild goose chase to check unrelated fuses seems unproductive. Sounds like it could be canbus related. I have seen old threads for this issue but they were so old not resolution. No old known issues?

Here is the rear wiper wiring diagram so you can see how the system works. I don't see a CAN BUS? That's why I ask if it all happened at once? Sorry for the confusion.

I'm even more confused. Yes, it all happened at once. Should I still check all the fuses? And if there all good?

Yes, check the fuses and more importantly see if the fuses have power. There must be a main feed that is not working. Start with the fuse for the rear wiper then I can trace it back.

Okay, a fuse was blown in under the hood box, everything working except dome light will not turn on when I open the driver's door with key or physically open it, dome light turns on all other doors open. swapped switches and still no light at driver's door. Newer switch on driver's door works on other doors.

I think it was the LED bulb that blew the fuse. The LED was dead and open when tested.

So, did the rear wiper fuse have power on both sides?

I never got that far. I purchased some 7.5 fuses to change out the corroded looking one under the hood. I could check then. Do I need to see if I have power at the wiper to fix the dome light not coming on with driver's door?

like i said i changed the under hood interior light fuse and the wiper works.

If you check for power at that fuse, I can see if the power feed affects the other circuits.

My mistake. The driver's door does turn on the light (very dimly) I thought it was ghosting because it's LED but that is not the case. I got some 7.5-amp fuses coming (I used a 10) I'll check more later.

I have power on both sides of the rear wiper fuse. In the dark the drivers door opening or key in door lock do not turn on the dome light. The dome light is/was(LED) ghosting, when I do the aforementioned it gets dimmer. I thought it was working dimly but i was wrong. All other doors turn on the dome light. The dome lights were not ghosting before this. And the back dome light work properly, no ghosting.

So, the rear wiper is getting power but still does not work, correct? I am starting to think this is a ground problem, has the wiring been tampered with?

No. I said everything works except this driver's door dome light thing.

What fixed the problem with the rear wiper?

changing the light fuse (7.5) under hood fuse box made everything work except the dome light works normal with all doors except diver's door. The dome light switch seems normal, on off auto - except the bulb ghost when in auto mode. I messed with the brand new D.D. switch and clean connection.

no answers?

How do I delete my questions from your site?

Sorry for the delay, So does the dome light not go off when the drivers door is shut but it goes off with the other doors?

The dome light (middle there are 3 dome map lights) works normal with all doors except divers door. The dome light switch seems normal, on off auto - except the bulb ghost when in auto mode with all doors closed and divers door open closed makes no difference, no full light open drivers door. I messed with the brand new drivers door. Switch and a very clean connection. I bypassed the driver's door switch by unhooking the wire and grounding to frame and the same no change.

The door light switch (pin switch) on the drivers door, can you please disconnect the wire to see if the light is out and if so ground the wire to see if the light comes back on? Here is the wiring diagrams so you can see how the system works. Check out the images (below). Let us know how it goes.

as previously stated, the driver's door switch installed or uninstalled/wire grounded or un-grounded has no effect.

Okay, we are getting warmer, the driver's door is the only door that goes through an integrated control unit. Let's try bypassing it to see if the dome lights start working correctly. Here is the location of the unit and I have marked the wires that need to be jumped. Check out the images (below). Let us know what you find.

Where is this under dash or behind kick panel and is this it?

It looks like it is under the dash on the driver's side. Please check out the images above.

yeah, I'm really confused it looks like it's part of the fuse box. Is this jumper supposed to be the fix or does the control unit need replacement?

Yes, it is part of the fuse box. If the jumper fixes it I would just leave it as a bypass. Let me know.

I don't know were the two wires are at to jump.

They connect to the integrated control unit.

which is on the back side of the fuse box? Which means removing the fuse box?

Chances are you will need gain access to the fuse panel back side. If you take an image and upload it I can tell for sure.

I'll drop it off to you.